Cheek Riser Slim Version for SBA3 | Multiple Colors and Heights Available

Cheek Riser for SBA3 available in different heights and colors. It will need to be extended a few positions (varies depending on setup) to run properly. Usually 4 positions.

• Battery Storage for 1" Version: The 1" version includes a storage tube that fits two CR123/A (not included) or 1 18650 (not included). The cap applies light pressure to the batteries to hold them in place. If there is any rattling, tighten the rear cap. No Standalone lithium batteries are sold with the product.
• Height Options: Available in different heights: .250" or .500" or .750" or 1"
• Secure Fit: Locking tabs on the side click into the slots on the side of the SBA3. This dual interface system ensures a tight fit without forward-to-rear movement. It is recommended to use a flashlight to ensure the tabs are lined up during the install process. To remove, push on the locking tabs on one side of the brace to detach and and push it off that side. The riser can then be rotated to get it off.
• Sight Compatibility: The taller versions of these risers will make the iron sights unusable. They are intended for use with an optic with a 1/3 co-witness or higher optic.
• Made in USA: 2200+ products designed and 3D printed in the heart of America in St Louis, Missouri by Hammy3DPrints.